security solutions

First, let’s talk about this BAS debugging. This BAS is the building automation system. It is not a simple thing. The debugging process must be taken seriously, and many things must be controlled. In fact, the so-called BAS debugging ultimate checklist covers a lot of content and can help us make this series of debugging tasks more comprehensive and complete.

Let’s break it down one by one below. Here is the first module: planning

One of them. There must be a clear plan, knowing in detail what operations are required, and knowing what debugging actions should be done and when. It is necessary to understand all aspects of system configuration

Follow the second note. The design description is to strictly compare the hardware and documents with the Ultimate checklist for BAS commissioning, check the equipment selection, etc.; and the third point is the personnel aspect, clarifying each debugging team member and which part will do what; and the fourth point in the planning: Once the equipment list is sorted out, you will know exactly what equipment to purchase and when to purchase it, etc. You should pay attention here, we need to find a reliable equipment purchaser, oh yes, we provide global procurement services for weak current intelligent products! You can try to find this website to choose equipment; the fifth step is to arrange the software update in this plan and find out where the requirements are.

Say it again. Next, the second big piece of content is the preparation stage.

The first point is to collect equipment-related data, technical specifications, function descriptions, maintenance documents, etc.; the second point is to set up the environment and check whether the electrical and network conditions are suitable; and then the third point is to make sure that the tools and various test software used for debugging are complete and easy to use; continue to pay attention to the fourth point to maintain interaction with the equipment manufacturers to find support when encountering problems; and the fifth step is to conduct a comprehensive inspection of the entire system before testing.

Let’s talk about the most critical step of this B As, the debugging and implementation part.

First of all: functional testing, testing various modules and various scenarios to ensure that the design indicators are met, such as control sensitivity and so on. Secondly, we need to pay more attention to debugging operating parameters, such as when the operating parameters of temperature and pressure are adjusted appropriately; thirdly, check the alarm and recovery mechanism of the entire system. If the operation is smooth, of course we should also pay attention to the problem alarms; followed by fourthly, we need to carry out linkage and interactive settings to ensure that the data connectivity and interaction of each subsystem are in place; and fifthly, real-time data collection and recording are required to evaluate the efficiency and effect of the entire system.

Next, let’s take a look at related frequently asked questions.

Q1: Why are there so many system communication failures?

This may be due to improper equipment matching, incoordination between equipment, cable signal interference, and erroneous signals. These will cause

Q2: Is the equipment damaged during debugging?

Severe environmental fluctuations, high temperatures and high humidity may cause damage to the equipment, or we may use incorrect parameter settings during operation and cause damage to the equipment.

Well, I personally think that if this is done according to such a complete set of checklist processes, then the B AS debugging can be done to ensure that our system can perform stably and effectively. Therefore, we keep every item in mind when debugging, and do not be lazy to ensure that the building automation can run stably, so that the operator can smoothly use this system to bring ease and convenience.